- EXTERNAL BATTERY CONNECTOR DIPTRACE HOW TO
- EXTERNAL BATTERY CONNECTOR DIPTRACE PRO
- EXTERNAL BATTERY CONNECTOR DIPTRACE SOFTWARE
EXTERNAL BATTERY CONNECTOR DIPTRACE HOW TO
In this post we look at figuring out how to route the Di2 wires through your frame so that you can put it all together.Īs the previous post states, you’ll need the following components: We’ve already published a post on what components are available and how to select them. I have 6 other mys nodes communicating with my gateway with no problems and greater distances (all using nanos).Īny suggestions? Apologies if this doesn't sound like an issue with the board, I can post in the troubleshooting forum if you think it's a radio problem.If you’re building a new Di2-equipped bike there are a couple of things you’ll need to decide.
![external battery connector diptrace external battery connector diptrace](https://www.wellpcb.com/sites/default/files/DipTrace4.jpg)
I have not yet tried swapping out the radio since it works with 5v, but I'm unsure what to try next. Strangely, the ONLY thing that worked was when I used the 5v post on my bench power supply (with the BAT jumper, no voltage converter)
![external battery connector diptrace external battery connector diptrace](https://lh6.googleusercontent.com/-NYXbCHSJRSk/Ukuaq927tLI/AAAAAAAAHB8/wFUCzxUZ_xA/s800/batt%20ifc%206s4p%202013r0%20b.png)
EXTERNAL BATTERY CONNECTOR DIPTRACE SOFTWARE
This could be a software problem but I include it as a clue. However, when measured I get it to around 1.6V (at no load).
![external battery connector diptrace external battery connector diptrace](https://cdn.macrumors.com/article-new/2017/03/switch-and-macbook-pro-800x469.jpg)
When the nodes fail, reported battery voltage is around 2.6V.
![external battery connector diptrace external battery connector diptrace](https://i0.wp.com/eetimes.com/wp-content/uploads/04-alc-0006-diptrace-component-editor-sm.jpg)
What battery life can I expect for a BMP280 on 2xAAA batteries and booster? Why isn't battery life better - am I missing anything obvious?Ĭan/should I remove C2 (10uF) and C3 (0.1uF) capacitors? I added them first but after checking the schematics I now think they are not used at all for the battery/booster setup?
EXTERNAL BATTERY CONNECTOR DIPTRACE PRO
LED and voltage regulator has been desoldered from the Pro Mini. I use NodeManager for software and report sensor values in 2 minute intervals. Both are 3.3V mini clones with NRF24 radios (probably clones) that run on 2xAAA batteries and a booster. Now then, I have a problem with battery life which is only around 3 weeks for my DHT22 node and around 8 weeks for my BMP280 node. First of all: I really appreciate the simplicity and flexibility of this board!